( 0 )

Component Die Cutting Machine In-Line With A Laminator

Component Die Cutting Machine In-Line With A Laminator

Component Die Cutting Machine In-Line With A Laminator-pic1

APMC would like to present the multiple electronic component die cutting machine in-line with a laminator. The machine synchronizes both laminating and cutting.The operation of machine is done in two steps to achieve the final product:

First Step: Release paper material is loaded on the centrally driven material stand, and it goes automatically through the lamination unit and then into the CAR-12PH. The male-female die will through cut the release paper material with some pre-product holes and small pinholes for use in registration, and then it is rewound back into a roll by the rewind stand. The male-female die accuracy is +/-0.1mm.

Second Step: The precut release paper material is loaded on the centrally driven material stand, and it goes automatically into the lamination unit. The lamination unit peels off the cover paper and then laminates the electronic foam material to the bottom release paper. Then it goes into the CAR-12PH. A plywood backed die will kiss-cut the laminated foam material to registration. Then, the waste web is peeled off using a separation knife and waste web rewind. A high quality die will result in a highly accurate cut. The remaining product tape material will be rewound by the material rewind stand.

                          Component Die Cutting Machine In-Line With A Laminator-pic2Component Die Cutting Machine In-Line With A Laminator-pic3