Elbow Pads (Toys Games and Sports)

These are machine(s) that can be used for Elbow Pads applications in the Toys Games and Sports industry. If you would like more information about any of these machine(s), select the machine(s) with the checkboxes on the left, fill out the form below and submit. You will receive a response as soon as possible. Thanks!

		Atom MF Series Oil-Dynamic Clicking Press With Turning Arm - A swing beam hydraulic presses sometimes known as a clicker. It is used to cut leather and man made materials. When choosing this type of machine the things to remember are: A. The material fits on the bed of the press. B. The die fits under the swing beam and does not stick out on either side. C. The amount of cutting rule is limited, so it does not overload the press.
		Atom SE Series Oil-Dynamic Clicking Press With Turning Arm - A swing beam hydraulic presses sometimes known as a clicker. It is used to cut leather and man made materials. When choosing this type of machine the things to remember are: A. The material fits on the bed of the press. B. The die fits under the swing beam and does not stick out on either side. C. The amount of cutting rule is limited, so it does not overload the press.
		USA Series Hydraulic Receding Head Presses - The receding head press is a very versatile die cutting machine. It has the benefits of both the full head press and the traveling head press. The bridge covers the whole cutting area. After a cut it recedes or goes back away from the operator leaving the cutting area open for easy access. With this type of operation one can use small dies or large dies and cut from sheets of rolls of material. The machine can kiss cut or cut to registration depending on what accessories are purchased.
		USA Traveling Head - The traveling head press is used to cut man made material that comes on rolls. The width can vary from 60” to over 100”. The bed depth generally runs from 20” to 30”. Larger machines can be provided to meet customer’s needs. The depth of the head is usually the same as the bed depth. The width of the head is normally the same as the depth. There are exceptions where it can be wider or narrower. The die should be smaller then the head of the press. The amount of cutting rule should be within the capacity of the machine. The cutting force can be from 20 to 150 tons. Different feed systems are available to assist the operator.

Name:
Email Address:
Company:
Phone Number:
Country:
Project Description: